N° 59
|
Positionskontrolle von Glasplatten Glas-Handlings-Maschinen müssen nicht nur über den Abstand zu einer Glasplatte informiert werden, sondern auch über die Kantenposition. Die Detektion der Glaskante kann sich jedoch als schwierig erweisen, falls die Glasplatte nicht abgefast wurde. Die direkte Reflexion auf einer Glasoberfläche beträgt bei senkrechtem Lichteinfall ca. 4%, bedingt durch die Reflexion an der zweiten Oberfläche kommt man damit in etwa auf 8% Reflexion in Summe, was zur exakten Kantenermittlung verwendet werden kann.
Position measurement of a transparent glass plate
Glass handling machines must be informed not only about the distance of a glass plate but also about the edge position of a glass plate. However the detection of the edge of a transparent glass plate is not so easy, especially if there is nearly no phase on the edges. The direct reflection rate of visible light on a standard glass surface is normally approximately 4% and with the additional reflection of the second surface around 8% of the light will be reflected.
|
|